Not found C:\Program Files (x86)\Arduino\hardware\Arduino_STM32-master\drivers\win where you will find install_drivers.bat and install_STM_COM_drivers.bat.Go to C:\Program Files (x86)\Arduino\hardware\Arduino_STM32-master\drivers\win where you will find install_drivers.bat and install_STM_COM_drivers.bat. Upload the source code, if no error the status must be:
STM32 DRIVER WINDOWS SERIAL
Your computer must be able to read Maple Serial in Device Manager These drivers are used if you are having issues connecting your flight controller to your PC. Unplug FTDI, connect directly from USB from PC to USB STM32 change BOOT0 = 0 BOOT1 = 0.
![stm32 driver windows stm32 driver windows](https://pcbartists.com/wp-content/uploads/2021/06/stm32-usb-device-not-recognized-solution.png)
When installation finish connect FTDI with Blue pillīefore flashing or connect to PC make sure BOOT 0 = 1 and BOOT 1 = 0, this step will setting chip on programming mode.After the package is installed, navigate to C:\Program Files (x86)\Arduino\hardware\Arduino_STM32-master\drivers\win where you will find install_drivers.bat and install_STM_COM_drivers.bat.
![stm32 driver windows stm32 driver windows](https://i.stack.imgur.com/0SnVg.png)
Update board manager by typing STM32F1 (This case using STM32F103C8T6 “Blue pill”) then Install.ģ. it’s more easier to do than using STLink or FTDI.Ģ. Now, we will try to debug STM32F103C8 by using USB Port and Arduino IDE as programming software.
![stm32 driver windows stm32 driver windows](https://techsmagic.com/wp-content/uploads/2020/08/1-53.png)
Usually, to debug STM32 using STLink or FTDI.